7
English
Brushing
Brush your teeth by moving the main body by hand.
• Choose the brush head depending on use and area.
When you want to make your teeth front surface and biting
surface clean.
• You cannot brush the periodontal pocket.
When you want to brush mainly the periodontal pockets or
between the teeth and gums.
•
You can also brush the teeth front surface and the biting surface.
Divide your teeth into 4 parts (upper and lower, left and right),
and brush one part in order such as “1 front of the teeth”, “2
biting plane of the teeth”, and “3 back of the teeth” spending
30 seconds.
Repeat this same procedure for the other 3 areas.
By brushing the above 4 parts for 30 seconds each (about 2
minutes), you can evenly brush your teeth without missing any
spots in your mouth.
1
• Apply the brush head at a 90° angle.
2
•
• Place the brush head at a 45° angle.
• Apply the bristles lightly into the periodontal pocket and
move the toothbrush slowly.
3
• Place the brush vertically.
• Move toothbrush to match the angle of the teeth.
Maintenance
How to clean
• Make sure that the main body is turned off.
•
After cleaning, store the brush with the protective cap attached.
1
2
Thoroughly rinse the inner and bottom of brush.
3
Note
•
Note the following precautions to avoid malfunction and damage.
•
Do not forcefully pull or force apart the bristles on the brush.
• Do not wash the brush with water over 80 °C.
• Do not damage or rub the waterproof rubber seal (c) with
hard materials.
• Do not wash the head with water over 40 °C.
• Do not immerse the appliance in water for a long time.
• Do not hit the appliance on the sink or any other object
while removing the water.
• Do not dry the appliance with a dryer or a fan heater.
• Do not wipe with thinner, benzine, alcohol etc.
Replacement parts
Replacement part is available at your dealer or Service Centre.
•
package. The labels can be attached on the brush to identify
users when they share the same toothbrush head.
ER‑6CT01
ER‑6CT02
To Next Page
Loading...
