ER-GB80/ER-GB70/ER-GB60
5
9. Loosen 6 screws and remove the motor and module
assembly.
10. Pull the chassis and module assembly upward.
NOTE:
Make sure to attach the O-ring.
11. Remove two screws, retaining plate, O-rings and water-
proof rubber.
12. Pull the motor assembly upward.
13. Slide up the trimmer and set the highest position.
Unhook the rear side of trimmer to separate from the
housing. (ER-GB80 and ER-GB70 only)
To Next Page
Loading...
