Panasonic ER-GC53 - Troubleshooting Guide

17
English
Lubrication
•Apply the oil to the clipper before and after each use.
•Make sure that the clipper is turned off.
1
Remove the blade.
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
ER-GC71
ER-GC63/ER-GC53
► Replacement parts
Replacement part is available at your dealer or Service
Centre.
Replacement parts
for ER-GC71/
ER-GC63/ER-GC53
Blade
ER-GC71:WER9615
ER-GC63/53:WER9605
Oil WES003
•Do not use any blade other than the one dedicated as
it may cause defect in performance.
•We recommend Panasonic oil WES003.
Troubleshooting
Perform the following actions.
If the problems still cannot be solved, contact the
store where you purchased the unit or a service
centre authorized by Panasonic for repair.
Problem Action
The blade has not
been cleaned
properly.
When the clipper is very dirty,
remove the blade and wash
with water. (See page 15.)
Makes a loud
sound.
Confirmthatthebladeis
properly attached.
The clipper has
become blunt.
Replace the blade.
(See page 16.)
Clean the blade and apply oil.
(See pages 15 to 17.)
PB017706 - ER-GC63 53������_(01GB)_04-25-19.indd 17 2019/4/25 15:04:17