Panasonic ES-LT2B - Page 16

16
English
▼
There are two ways to clean the shaver,
depending on the actual dirt level�
▼ ▼
To remove light dirt To remove heavy dirt
3. Slide the cleaning
shutter until it clicks.
•
The water inlets of the
shaver head are opened.
WATER THROUGH
4. Pour running water into
the water inlets and
rinse thoroughly, and
thenturno󰀨.
• Pour running water
into both water inlets.
• Rinse with water and
shake up and down
several times to remove
the water, and then close
the cleaning shutter.
WATER THROUGH
3. Turntheshavero󰀨and
remove the outer foil
section. (See page 17.)
4. Clean the shaver and
the outer foil section
with running water.
• Rinse with water and
shake up and down
several times to
remove the water.
▼ ▼
▼ ▼
5. Wipeo󰀨anydropsofwaterwithadrycloth.
6.
Dry the outer foil section, the
shaver, and the trimmer completely.
• Allow the shaver to dry in the
shade, avoid direct sunlight.
7. Lubricate the shaver.
It will keep the movement of the
blade smooth and maintain a
comfort shave.
1. Apply one drop of oil to each
of the system outer foils.
2. Raise the trimmer and apply
a drop of oil.
3.
Switch the shaver on, and run it
forapproximatelyveseconds.
4. Switcho󰀨theshaver,and
wipeo󰀨anyexcessoilfrom
the system outer foil with a
soft cloth.
►Notes
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, cracking or
discoloration of the parts.
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.