18
5
Lubricate the shaver�
It will keep the movement of
the blade smooth and
maintain a comfort shave.
1. Apply one drop of oil to
each of the system outer
foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
Cleaning with the brush
Cleaning with the long brush
Clean the foil frame [A3],
system outer foil [A2], the
main body [A] and the
trimmer [A;] using the
long brush.
Cleaning with the short brush
• Clean the inner blades [A]
using the short brush by moving
it in direction as illustrated.
• Do not move the short brush
perpendicularly against the
blades as it will damage the inner
blades and affect their sharpness.
the inner blades
system outer foil once every year
inner blades once every two years
Removing the outer foil section
Press the foil frame release buttons [
A4
]
and lift the outer foil section [
A8
] upwards.
Attaching the outer foil section
After turning the foil frame mark (
) to the
front, securely attach the outer foil section
[A8] to the shaver until it clicks.
1. Press the system outer foil release
buttons [A9] and pull down the
system outer foil [A2].
To Next Page
Loading...
