17
English
5
Dry the outer foil section and the
shaver completely�
• Allow the shaver to dry in the shade, avoid direct
sunlight.
6
Lubricate the shaver�
1. Apply one drop of oil to each of the
system outer foils.
2. Switch the shaver on, and run it for
approximately ve seconds.
3. Switch o the shaver, and wipe o
any excess oil from the system
outer foil with a soft cloth.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
Cleaning with the brush
Remove the outer foil section and the inner blades.
(See page 18.)
Do not use any brush other than the supplied one.
► Cleaning with the short brush
• Clean the inner blades using the short
brush by moving it in direction as
illustrated.
• Do not move the short brush
perpendicularly against the blades as it
will damage the inner blades and aect
their sharpness.
► Cleaning with the long brush
Clean the foil frame,
system outer foil and
the main body using
the long brush.
► System outer foil
Clean the system outer foil in the
areas indicated by the circles every
time you use the shaver. Otherwise,
abnormal sound may be generated.
To Next Page
Loading...
