13
RO H SK CZ PL FIN S N P DK E NL I F D GB
Abnormal charging
ES-RT67 ES-RT47/ES-RT37
The charge status lamp ( ) blinks twice every second.
• After charging is completed, turning the power switch ON
with the shaver plugged in will cause the charge status lamp
(
) to light up and then turn off after 5 seconds.
This shows that the shaver is fully charged.
• Recommended ambient temperature for charging is
10 – 35 °C. It may take longer to charge or the battery may
fail to charge properly in extremely high or low temperatures.
Charge the shaver within the recommended ambient
temperature range.
• When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charging time may
change or the charge status lamp (
) may not glow for a few
minutes. It will eventually glow if kept connected.
Using the shaver
• Do not place your fingers on the power switch while using
the shaver. This may cause the shaver to turn off. Place your
fingers on the finger rest while using the shaver.
• We recommend using the shaver in an ambient temperature
range of 5 – 35 °C. If used outside this range, the appliance
may stop operating.
1
1
Press the power switch [A6].
• The switch on lamp glows.
ES-RT67
2
2
Hold the shaver as illustrated
and shave.
• Start shaving by applying gentle
pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the
direction of your beard. You may
gently increase the amount of
pressure as your skin becomes
accustomed to this shaver. Applying
excessive pressure does not
provide a closer shave.
Using the trimmer
►Trimming sideburns
Slide the trimmer handle up. Turn the
shaver on and place at a right angle to
your skin and move downwards to trim
your sideburns.
• Press and hold the lock release button
and slide the trimmer handle down to
lower the trimmer.
To Next Page
Loading...
