SETTING UP
1. Lift up the front end and move the unit by rolling it on the wheels.
Notes
Do not move the unit while holding the bridle bar.
Do not step on the power plug while moving the unit.
Slowly lift and move the unit while taking care not to injure your lower back.
•
•
•
2. Lay out the supplied mat and place the unit on the mat.
* Lay out the mat so that the rubber surface faces down.
When laying out the mat, a space of 80 cm to
the left and to the right and 60 cm to the front
and to the rear of the mat is required.
(see illustration)
Notes
When using the unit on carpet, marks may
remain on the carpet even if the unit was
first placed on the mat.
If there is concern about vibration or noise
downstairs, lay out a thick mat that is
commercially available.
•
•
•
Caution
Be sure to place the unit on the mat
before use.
- Using the unit without the mat may
result in scratches on the floor.
•
Wheels
Mat
To Next Page
Loading...
