How to use
1
Pull out the main body while
rotating it, and then install the
nozzle.
a
Open the water tank cap.
• If it is closed, the main body
is hard to be pulled out.
b
Pull the main body to the
"
" mark.
• Be noted that the nozzle
may be ejected from the
nozzle storage unit.
c
Install the nozzle while
holding the main body.
• Install it into place until it
clicks.
2
Fill the water tank with water.
a
Add water while keeping the
main unit level.
• Do not ll beyond the
full-water position.
b
Close the water tank cap
securely.
• Always use new tap water or
lukewarm water.
• If you feel the water is cold,
use lukewarm water with a
temperature of 40 °C or less.
If the water tank cap
comes o
• Align the groove of the
water tank cap with the
protrusion of the water
supply port, and press the
water tank cap into place
until it clicks.
3
Press the level switch to
select your desired water
pressure level.
LEVEL
• After you press the level
switch, the last used water
pressure level is automatically
selected. Then each time
you press the level switch,
the water pressure level is
switched once in the following
order: 1 (weak) → 2 → 3 → 4
(strong) → 1...
Full-water position
Press
Strong
(water pressure level 4)
Weak
(water pressure level 1)
Click
Protrusion
Groove
11
PB021640 - EW-DJ31 ������_(01EN)_06-22-22.indd 11 2022/6/22 11:50:39
To Next Page
Loading...
