Panasonic EY7410 - Main Switch (ON;OFF); Speed Selector Switch; Main Switch Lock

- 7 -
●Do not look atthe light or shine it
directly into your eyes.
Continuous exposure to the LED
light may damage your eyes.
1. Press to toggle the light on
and off.
●To use the light immediately after
attaching the battery pack or after
the drill has not been used for 5
minutes or more, operate the drill
briefly.
●The light will automatically turn
off if the drill is not used for 5
minutes.
●The light uses an extremely small
amount of current. Using the light
has a negligible effect on the
operational capacity of the drill.
● The LED is incapable of lighting
the tip of the bit when the drill is
usedinthestraightconguration.
Bit-locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 14.7 N·m
(150 kgf-cm, 130 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
Forward
Forward
Reverse
Reverse
Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be select-
ed.
HIGH
LOW
Speed selection Torque
LOW 200 /min (rpm) High
HIGH 600 /min (rpm) Low
CAUTION:
• Check speed selector switch before
use.
• Do not operate the speed selector
switch while the main switch is on
(switch is in the ON position).
Main Switch Lock
After use, set the main switch lock at
the lock position to prevent accidental
operation.
EY7410(EU).indb 7 2006/07/19 17:27:48