VR401
29
Confirmation and
preparation
4
Remove the tray, fill it with water,
and install it back.
(Water is not required when the product operates in “Clean air” mode.)
Remove the tray.
Fill it with water.
Hold the tray handle and carry the tray taking care not to tilt it.
Reinstall the tray slowly.
Fill the tray with water Turn on
Be sure to use the tap water
(This is because tap water is normally
chlorine-disinfected to prevent breeding
of bacteria.)
●Do not use the following water:
● Water above 40 °C or mixed with
detergent. (Otherwise, deformation or
failure may occur.)
●
Water mixed with chemicals, air fresheners,
or essential oil. (It may damage the tray and
cause spillage or wet the furniture. :P.27)
●
Water from water purifier, ionized alkaline
water and well water. (It may cause mold
or bacteria.)
Attention
●If you have to use the well water
(drinkable), please maintain and clean
the tray, the humidifying filter, the filter
frame more frequently.
Continuous operation time of a
tray of water
●Operates for about 4.6 hours. (Under
the condition of [ (High)] / room
temperature 20 °C and humidity 30 %)
5
Connect the power
plug.
Wipe the water off the
power plug and your
hands before inserting it.
● Press , and the clean
sign (P.30) blinks blue or red for
about 5 seconds.
満水ここまで
Push the tray handle down
to the humidifying filter side.
Push the tray back
until it clicks.
[ ]
indicates the
upper limit line.
(If water is poured
above the line,
water is likely to
spill.)
Guide of full
capacity
To Next Page
Loading...
