34
Tray
Care and maintenance
Before cleaning
Be sure to disconnect
the power plug.
●Do not use the detergent other than the neutral one for
kitchen purpose. (Deterioration, deformation or breakage
of plastic parts may occur.)
●You can use the oxygen-based bleaching agent only when
cleaning the humidifying filter.
● When using chemically treated cloth, follow its instructions.
To remove the stubborn stains
How to soak and wash
Dissolve neutral detergent for kitchen purpose or
citric acid well in warm water (below about 40 °C).
Soak the parts for 30 minutes. Rinse with clean
water 2 to 3 times.
● Rinse enough, otherwise, the remaining detergent
may smell or failure may occur.
●Tray
●Filter frame
Wash with water containing the neutral
detergent for kitchen purpose or citric
acid.
(Anti-fungus
assembly)
Soaking
●
Humidifying filter
After soaking, press and wash.
٭The ratio of citric acid to warm water is 20
to 3 L.
٭1 As the dirtiness varies depending on the
water quality, maintenance may be required
even within one month after the last
maintenance. If it smells unpleasant or water
in the tray decreases less than before, clean
the tray.
Attention
●Do not operate without the humidifying filter.
(It makes it impossible to obtain the effect to humidify air.)
●
Drain after removing the tray. Do not drain with the tray installed.
(Water may enter inside the body, and failure may occur.)
Tray
<About once a month>٭
1
Wash with water.
Floater
●Wipe the dirt in details with cotton
swab or toothbrush.
●Do not remove the floater
(polystyrene foam).
●Stubborn stains
→ (To remove the stubborn stains)
(continued)
Tray
To Next Page
Loading...
