Panasonic F10 MARK II - Page 19

51. Hooks for Camera Strap
When using Camera Strap (WV-OQ44E), hook the both ends
of Camera Strap to these hooks.
52. Cheek Pad Lock Screw
Fix
the
cheek
pad
on
the
rear
of
the
camera
by
rotating
this
screw clockwise.
53. Adjustable Shoulder Pad
The shoulder pad can be extended approx. 40mm for
comfortable position.
56.
57.
54. Grip Release Screw
Turn the screw counterclockwise for releasing the Grip
Shoulder if necessary. 58
55, VTR Start/Pause Switch
This push-push type switch is used to change VTR mode
from Record/Pause to Record, Push the switch once and
the VTR will start to Record as shown by the blinking
REC graphics in the viewfinder,
=a
Push the switch again to Pause (Record/Pause) the VTR
and the blinking REC graphics will disappear.
Note: When the REC graphics indication and VTR
Start/Pause operation is reversed, change the
Position of VTR compatibility switch (RUN,
@/O6) (29).
Adjustable Handheld Strap
The handheld strap can be adjusted for holding the camera
firmly.
White Fade/Black Fade Selection Switch (WHITE/BLACK)
When operating the Fade-in/out Button (43), this function
offers an additional feature.
In case that the WHITE mode is selected, the fading-in or
fading-out picture ends to white scene. And if the BLACK
mode is selected, the fading-in or fading-out picture ends to
black scene.
Shutter Speed Selection Switch
When operating the Strobe Effect Shutter mode (14), this
function should use with it. WV-F10 MARK II offers five
different speeds, 1/120, 1/250, 1/500, 1/1000 and 1/2000
seconds. :