Panasonic F10 MARK II - Page 45

STROBE EFFECT SHUTTER OPERATION
A newly developed Fi0 MARK li equips with a 5 step Strobe
Effect Shutter mode, 1/120, 1/250, 1/500, 1/1000, 1/2000 sec.
When the Strobe Effect Shutter/Normal Selection Switch (SES/
NORMAL) (14) is set to SES position, video signal of selected
step in every 1/50 sec is provided and a fast-moving object can
be produced as blur-free and precise slow-motion picture.
(The picture below shows 1/1000 sec for example)
> Ss 19) | ____..
: :
|
!
t 1
} H
Ss
|
a
11000
1/1000
Eval
Sec.
fe
n0
t--
>
+
1/50
Sec,
Sec.
1/50
Sec.
--—--
ca
;
When a fast-moving object is shot with normal mode, picture of
slow playback mode may have vibration. However if it is shot
with SES mode, vibration can not be seen.
Note: 1) The strobe effect shutter can not be recom-
mended in the following condition.
oUnder low illumination (minimum required
illumination at F1.4 is calculated as 1/(5XSES
speed)
o Under fluorescent illumination
—~40 —
VTR REMOTE CONTROL PLAYBACK OPERATION
The portable VTR playback can be remotely controlled from the
camera only when the camera is connected with portable VTR
such as Panasonic NV-180 which has the Camera Select Switch.
The following are the operating procedure for the playback
operation as;
1. Set the Camera Select Switch on the portable VTR to the
REMOTE position.
CAMERA SELECT
NORMALE § REMOTE
2. Set the Record/Playback Selection Switch to the PLAY
position. The picture in the EVF or color video monitor
shows the still picture.
REV > &) &) PLAY
qe — OATE —. neqspos-—~ REC
gute ~~” NEG/POS
SET —— SEQ — sip} ————-——*
3. Press the » (playback) button on the keyboard for playback
picture.
e+ Oe aw 7
) 00 0 lo) &
TITLE —~ DATE — pi a REC
Tae EG/POS
S€T —— SEQ — SHIFT