6-5
Unpacking/
Installation
Location Shipping material/Procedure Check
Turn the power switch ON
TDC adjustment
(1) Press the “User Preset”, “Ledger/
A3 of Original Size” and “3” keys
simultaneously to enter the F
mode.
(2) Press the “8” key to enter the F8
mode.
(3) Press the “Print” key.
(4) Press the “0”, “9” keys to enter the
F8 mode code “09”.
(5) Press the “Print” key for automatic
TDC sensor gain adjustment.
(Wait approximately 2 minutes until
the adjustment cycle stops.)
(6) Write the contents of F6-21 and 26
on the memory sheet.
Black density sensor output gain
adjustment
(1) Press the “1” and “4” to enter the
F8 mode code “14”.
(2) Press the “Print” key for automatic
black density sensor output gain
adjustment.
(3) Write the content of F6-65 on the
memory sheet.
(4) Press the “User Preset” and
“Clear/Stop” keys simultaneously
to escape from the F mode.
8(a)
8(b)
7
To Next Page
Loading...
