6-9
Unpacking/
Installation
Location Shipping material/Procedure Check
3. Side to side adjustment (Duplex)
(1) Pull the duplex unit tray out until it
stops.
(2) Loosen the four screws of the front
cover.
(3) Move the front cover as required,
then tighten the screws.
Note: Move the front cover evenly.
(left and right sides)
4. Registration adjustment
(1) Press the “User Preset”, “Ledger/
A3 of Original Size” and “3” keys
simultaneously to enter the mode.
(2) Press the “6” key to enter the F6
mode.
(3) Press the “Print” key.
(4) Press the “0” and “5” keys to enter
the F6 mode code “05”.
(5) Press the “Print” key.
(6) Enter the new content.
Note: The “Reset” key is used to
enter the “–” content.
(+): Paper feed timing is
delayed
(–): Paper feed timing is
advanced
(7) Press the “Print” key.
(8) Press the “User Preset” key and
“Clear/Stop” keys simultaneously
to escape from the F mode.
(9) Make a copy confirm the
adjustment.
To Next Page
Loading...
