Panasonic FP-7722

Programming Copy Jobs
|
Mi Two copy jobs can be programmed in memory (M1 or M2) for recall at a
later time.
(m)@(m2) Keys Copy Count Display
(FP-7718/7722)
To store a job in memory (1) Set up the copy job to be stored in
memory
(2) (Gey Memory In Key
FP-7718/7722 The copy count display will flash
FP-7728/7735 | Ready to program
select Mem #
@ () a Coy
“)
6
ES
; a
maa
20
aS)
5)
o£
8 E
oO
Is
=
o 2
Oa
To
recall
a
job
stored
in
D
(1)
or
RN
memory
The job stored in each memory location can be
changed if necessary
(2) Press Print
NOTE @ When using the skyshot mode (M1 and M2 are turned ON), job memory
cannot be used
@ Job memory mode will not be deleted even if power switch ts turned off
@ When storing a new job, the previously stored job will automatically be
deleted and the current job stored in its place
19