5-3
Trouble
Shooting
Detection of Paper Jam
• FA-S620/S660 copy paper transport condition is monitored by the sensors
shown below. When paper is jammed, the jam position indicator (
) blinks. at
the same time, "paper jam" is memorized by code number (J60). (Maximum 10
occurrences including options.)
• To recall paper jam codes, refer to the copier service manual "F8-06".
(a) Jam conditions
• When the sorter paper feed sensor does not detect paper within a predetermined
time after the paper exit sensor in the copier detects paper.
• When the sorter paper exit sensor does not detect paper within a predetermined
time after the paper feed sensor in the sorter detects paper.
• When the sorter paper feed sensor and the sorter paper exit sensor detect
paper when the power switch is turned on.
To clear "paper jam" indication, remove the paper, reset the sorter mode and
select the sorter mode again.
(e) oF: Paper detection trouble
When the number of sorted copies received by a sorter bin exceeds the specified
number of copies.
To clear "oF", remove all the copied sheets.
(2) Paper Jam
Does the output from (J11-6, 8:
S620/J7-7, 8: S660) change when
the staple cartridge is in and out?
• Staple detecting switch (MS5)
failure---replace the sensor.
NO
To Next Page
Loading...
