Panasonic FP-7830 - Page 338

5-6
E7-01Bin motor failure
Does the output of (J1-2: S620/J5-5:
S660) change when the reed cam home
position sensor is turned ON/OFF?
• Sensor is not mounted
correctly or sensor failure.
Is DC+24V generated between (J5-1
and 2: S620/J8-1 and 2: S660) with
the rotation of bin motor?
Lifting up: J5-1/J8-1: +24V
Lifting down: J5-2/J8-2: +24V
YES
NO
NO
• Check DC+24V of the sorter
controller CPU.
Bin motor failure.
YES
E7-07 Stapler swing motor failure
Does the output of connector (J8-2: S620/
J7-1: S660) change when the stapler unit
home position sensor is turned ON/OFF?
NO
• Sensor is not mounted
correctly or sensor failure.
YES
Is DC+24V generated connector
J12-1 (S660) with the rotation of
stapler swing motor?
NO
• Check DC+24V of the sorter
controller CPU.
YES
Bin motor failure.