Unpacking/
Installation
6-15
Location Procedure
Check
(1) Remove 2screws of the rear
cover (copier and system con-
sole).
(2) Install the connecting plate to the
rear cover (copier and system
console).
(2 screws, just removed)
15
Install the floor stabilizer to the system
console.
(2 screws, M4 X 14)
Note: Put the floor stabilizer com-
pletely on the flower.
Insert the rail assembly into the lower
slits of copier left cover, then fix the
rail assembly. (2 screws, M4 X 33)
Connecting plate
16
fall stabilizer
14
To Next Page
