Panasonic FP-7830 - Page 53

Preventive Maintenance
4-13
2) Replacement of the DFP roller and the torque limiter
3) Replacement of the Middle roller
1) Conduct the procedure 1 and 2.
2) Remove the lower roller cover (2 screws)
3) Remove the touch ring.
4) Remove the DFP roller.
5) Remove the torque limiter.
Note: Confirm the direction of the torque
limiter when re-installing it.
[Fit the positioning pin (rear side)]
4
5
1) Conduct the procedure 1 and 2.
2) Remove the E ring gear on middle roller.
3) Remove the touch ring and bushing.
4) Slide and remove the middle roller.
3
2
4
1