4-20
1) Replacement of cleaning web/web pressure roller
(1) Open the front cover.
(2) Swing the toner hopper to the right.
(3) Remove the fuser unit manual paper feed
knob. (1 screw reverse threaded)
(4) Remove the front cover.
a) Remove the band.
b) Slide out the hinge pins.
(5) Remove the fuser front cover (2 screws).
(1) Disconnect the fuser unit connector (x 2).
(2) Open the two LWS (x 2).
(3)Open the paper exit unit.
(4)Remove the fuser bracket (3 screws).
(5) Carefully slide the fuser unit out of the
front of the machine.
2
1
(1) Remove the web ass'y bracket screw
(x 2).
(2) Slide the web ass'y to the right and
remove.
3
4
(1) Remove the bushings (2 screws) and
rollers (x2).
(2) Install the new web as shown.
(3) Make sure to remove the slack in the
supply roller.
(4) Make sure the take-up drive is working
normally.
4a
4b
4b
2
5
3
5
1
1
4
2
2
1
3
1
1
2
3
4
1
To Next Page
Loading...
