Preventive
Maintenance
4-27
5
(1)Remove the platen cover (or ADF/i-ADF
if installed).
(2)Remove the copier front cover (refer to
page 4-18 step 1).
(3)Disconnect the lattice connectors of any
options (System Console and LCC).
(4)Remove the rear cover (7 screws).
3) Replacement of the optics motor belt/full-speed unit drive belt/half speed unit
drive belt
6
(1)Remove the copier top left and right
covers (4 screws).
(2)Remove the original guide, platen glass
and top rear cover (5 screws).
(3)Remove the copier left and right covers
(4 screws).
7
Remove the control panel ass’y.
(1) Remove the 4 screws.
(2) Disconnect the 2 connectors.
(3) Remove the ground wire (1 screw).
8
(1)Swing the toner hopper ass'y 180
degrees to the right.
(2)Remove the right side control panel ass'y
bracket (1 screw).
(3)Remove the inner front cover (3 screws).
4
3
3
4
4
4
1
3
3
1
2
2
1
1
3
2
1
To Next Page
Loading...
