Preventive
Maintenance
4-31
Connect the half-speed unit drive belt
(1) Move the half-speed unit to right until it
stops.
(2) Connect the half speed drive belts
(each side).
Note: If the half-speed unit has not
touched the stopper after the belt
is connected, loosen screw on the
half-speed unit support plate and
adjust the half-speed unit position.
21
Connect the full-speed unit drive belt
(1) Install the belt fixing plate on the
full-speed unit drive belt (each side).
(2) Move the full-speed unit to right until it
stops.
(3) Tighten screws on the full-speed belt
fixing plate. (each side)
20
Stopper
1
3
1
2
To Next Page
Loading...
