2. Attach the hand strap.
• Pass the straps through the left and right upper strap attachment holes (D), pull them firmly to the
end (E), and then pass them through the buckles (F).
• Unfold the stands (G), attach the straps attached in step 1 to the buckles (H), pull the belts firmly
(I), and then fold the stands (J).
• To remove the hand strap, unfold the stands (K), and press the buckle protrusions (L).
Adjusting the hand strap
Open the cover, adjust the hand strap to fit your hand, fold back and fasten the belt, and then fold the cover.
• Make sure that the ring does not go past the stopper (A). If it does, the belt may get detached from the
ring and the unit may fall.
• The part where you insert your hand can be rotated.
Replacing the batteries
To replace the batteries, unfold the stands in step 2 above (K), press the buckle protrusions (L) to remove
the straps, and lift the hand strap.
Attaching the shoulder strap
You can attach the shoulder strap (CF-VNS331) to the rings of the hand strap.
Operating Instructions - Reference Manual 55
Supplementary items
To Next Page
Loading...
