Panasonic FZ-G1 Series - Page 8

8
Getting Started
First-time Operation
5 <For MUI OS model>
Select language and OS (32-bit or 64-bit).
CAUTION
l
Carefully choose your language because you cannot change
it later. If you set a wrong language, you need to reinstall
Windows.
NOTE
l
You can operate with the Tablet Buttons. Follow the
instructions.
:
↑
:
↓
: Enter key
: Tab key
A
Select language and OS (32-bit or 64-bit) on “Select OS”
screen and touch [OK].
Thelanguagesettingwillstartbytouching[OK]ontheconr-
mation screen.
The language and OS setting will be completed in about 15
minutes.
B
When termination screen is displayed, touch [OK] to turn off
the computer.
C
Turn on the computer.
6 Setup Windows.
Select language and touch [Next].
Turn on the computer.
Follow the on-screen instructions.
l
The computer restarts several times. Do not touch the screen
or tablet buttons, and wait until the drive indicator has
turned off.
l
After the computer is turned on, the screen remains black or
unchanged for a while, but this is not a malfunction. Wait for
a moment until the Windows setup screen appears.
l
Setup of Windows will take approximately
5 minutes / 20 minutes.

Gotothenextstep,conrmingeachmessageonthedisplay.
l
Follow the steps below.

A
When “Enable sensors” is displayed, touch [Enable this
sensor].

B
When the [User Account Control] screen is displayed,
touch [Yes].

C
Atthe[DisplayRotationTool]conrmationscreen,touch
[Yes].

The computer restarts automatically, and the setting is en-
abled.