40
VQT2N35
The unit is put into recording pause approx. 1 second when the power is turned on with the
mode set to or .
≥ Depending on the recording conditions, start time may be longer than 1 second in still
picture recording mode.
≥ In the quick power on mode, the zoom magnification becomes 1k.
This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is
reopened.
≥ Start time will not shorten if there is no SD card inserted.
Start time will be shorten if the [Built-inMemory] is selected in the [MEDIA SELECT], even if
there is no SD card inserted.
Start time will be shorten if the [HDD] is selected in the [MEDIA SELECT], even if there is
no SD card inserted.
≥ Change the mode to or .
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
or .
The status indicator A flashes green and the unit goes into
quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥ When in quick start standby mode about 80% of the power used in recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ Depending on the recording conditions, time for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white balance to adjust.
≥ In the quick start mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 39) is set to [5 MINUTES] and the unit automatically goes into quick
start standby mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
[QUICK POWER ON]
[OFF]/[ON]
[QUICK START]
[OFF]/[ON]
To Next Page
Loading...
