mm
vIDLAE_JIPHOTOI
Shutter Speed:
Adjust it when recording fast-moving subjects.
Iris:
Adjust it when the screen is too bright or too dark.
• Press the iA/MANUAL button or CAMERA FUNCTION button to switch to Manual
Mode. (-_ 82)
• For how to perform the settings when using the viewfinder, refer to page 82
/ Touch [SHTR] or [IRIS].
2 Touch _/[_ to adjust settings.
SHT.=_RShutter speed:
1/60 to 118000
• If [AUTO SLOW SHTR] is set to [ON], the
shutter speed will be set between 1/30
and 118000.
• If [DIGITAL CINEMA] is set to [ON], the
shutter speed will be set between 1/48
and 118000. (When [AUTO SLOW SHTR]
is set to [ON], the range is 1/24 to 118000.)
• The shutter speed closer to 1/8000 is faster.
• The shutter speed will be set between 1/2
and 1/2000 in Still Picture Recording Mode.
_R___sIris/Gain value:
CLOSE _ (F16 to F1.7) _ OPEN _ (0dB
to 18dB)
• Value closer to [CLOSE] darkens the image.
• Value closer to [18dB] brightens the image.
• When the iris value is adjusted to brighter
than [OPEN], it changes to the gain value.
• To return to auto setting, press the iA/
MANUAL button again.
• When setting both the shutter speed and
the iris/gain value, set the shutter speed
and then set the iris/gain value.
Manual shutter speed adjustment
• When the shutter speed is set lower than
1/15 in the Still Picture Recording Mode,
using a tripod is recommended. Also,
white balance cannot be set. The shutter
speed will be set to 1/30 when the power
is turned on again or when the Quick start
is performed.
• You may see a band of light around an object
that is shining very bright, or highly reflective.
• During normal playback, image movement
may not look smooth.
• If you record an extremely bright object or
record under indoor lighting, color and
screen brightness may change or a
horizontal line may appear on the screen.
In this case, record in the intelligent Auto
Mode or set the shutter speed to 1/60 in
areas where the power supply frequency
is 60 Hz, or 1/100 in areas of 50 Hz.
Manual iris/gain adjustment
• Luminance level and histogram are
displayed during the iris adjustment.
(-) 76, 77)
• If the gain value is increased, the noise on
the screen increases.
• Depending on the zoom magnification,
there are iris values that are not displayed.
84
VQT2M75
To Next Page
Loading...
