19
(ENG) SQT0885
∫ Preparations before connection
1 Install the smartphone application “Image App” on your smartphone. (l 18)
2 Turn on the Wi-Fi function of your smartphone.
≥ For further details, please read the operating instructions for the smartphone.
Setting up a Wi-Fi connection to a smartphone
≥ Check that the Wi-Fi lamp is off.
1 Press and hold the recording mode/Wi-Fi button for at least
1 second (approx.), and remove your finger.
≥ The Wi-Fi lamp will flash red.
2 Tap the SSID of this unit (below) on the Wi-Fi network
screen of the smartphone.
≥ Password entry screen is displayed.
3 Enter password (below).
≥ When the connection is complete, the Wi-Fi lamp of this unit will light red.
Use your smartphone to set up this unit.
Preparation:
1 Set up a Wi-Fi connection between this unit and the smartphone.
2 Start up the smartphone application “Image App”.
≥ If a connection attempt to this unit fails, turn off and on the Wi-Fi function using the setup
menu of the smartphone, and then retry the connection.
≥ For more information, refer to the [Help] in the “Image App” menu.
Preparation
Connecting to a smartphone
Default setting
SSID:
Password:
A1-wearable
a12345678
Preparation
Setting up this unit
≥ When you start “Image App” connecting with this unit for the first time, a message
asking you to set the date and time will appear. (This message will also be displayed if
this unit remains unused for a long period of time.)
Follow the message to set the date and time.
≥ When you turn on this unit for the first time, a message asking you to change the SSID/
Password will appear. Be sure to change them. Otherwise, third parties may intercept
your information or use it for malicious purposes.
HX-A1M-SQT0885_mst.book 19 ページ ２０１５年６月１日 月曜日 午前９時５８分
To Next Page
Loading...
