25
(ENG) SQT0885
1 While holding D, loosen the adjustment belt B
until this unit can be passed through it by rotating
the tightening nut C towards UNLOCK.
2 Pass this unit through the adjustment belt B so
that this unit is in the position shown in the figure.
3 While holding D, tighten the adjustment belt B by
rotating the tightening nut C towards LOCK until
this unit is fastened securely.
≥ Adjust the adjustment belt with hands. Do not apply too much
force.
≥ Do not rotate the tightening nut more than necessary after
fastening this unit.
≥ Check the direction of this unit after attaching it.
≥ To correct the left/right tilt of this unit, loosen the adjustment
belt.
While holding D, loosen the tightening nut C by
rotating it towards UNLOCK, and remove this unit.
≥ This unit is not waterproof when the terminal cover (USB connection) is in use. In this case, do
not use this unit underwater or touch it with wet hands.
Attaching this unit to the Tripod Mount
Removing this unit from the Tripod Mount
UNLOCK LOCK
HX-A1M-SQT0885_mst.book 25 ページ ２０１５年６月１日 月曜日 午前９時５８分
To Next Page
Loading...
