Location of Controls
Location of Controls
Q LCD (Liquid Crystal
Display)
W PAUSE: Used to insert a
pause when storing a
telephone number. This
button is also used for
programming this unit.
E
FWD/DND (Call Forwarding/
Do Not Disturb):
Used to set
Call Forwarding or Do Not
Disturb on your extension.
R CONF (Conference): Used
to establish a multiple party
conversation.
T INTERCOM: Used to make
or receive intercom calls.
Y AUTO ANS (Auto Answer)/
MUTE: Used to receive an
incoming call in hands-free
mode or mute the
microphone/handset during a
conversation.
U AUTO DIAL/STORE: Used
for System/Personal Speed
Dialing or storing
programme changes.
y
o
t
}qw
U
I
O
{
Q
T
Y
W
R
P
p
e
r
<KX-DT346>
i
E
u
Location of Controls
I TRANSFER: Used to
transfer a call to another
party.
O REDIAL: Used to redial the
last dialed number.
P
MESSAGE: Used to leave a
message waiting indication
or call back the party who left
the message waiting
indication.
{ Headset Jack
} FLASH/RECALL: Used to
disconnect the current call
and make another call
without hanging up.
q HOLD: Used to place a call
on hold.
w SP-PHONE
(Speakerphone): Used for
performing hands-free
operations.
e
ENTER: Used to assign the
selected item.
r Microphone: Used for
hands-free conversations.
t Navigator Key: Used to
adjust the volume and the
display contrast or select
desired items.
y CANCEL: Used to cancel
the selected item.
u
Flexible Buttons: Used to
seize an outside line or
perform a feature that has
been assigned to the key.
i LCD Panel: Can be adjusted
to the desired angle.
o Soft Buttons (S1-S4): S1-
S4 (located from left to right)
are used to select the item
displayed on the bottom line
of the display.
p Message/Ringer Lamp:
When you receive an
intercom call, the lamp
flashes green, and for an
outside call, the lamp flashes
red. When someone has left
you a message, the lamp
stays red.
To Next Page
Loading...
