Panasonic KX-FLM551 - Page 201

Bit No. DIS/DTC DCS
33
(0)
(1)
Validity of bits 17, 18
Bits 17, 18 are valid
Bits 17, 18 are invalid
Recording width
Recording width indicated by
bits
Recording width indicated by
this
information
34 Recording width capability 1216 picture
elements along scan line length of 151 ±
mm 1%
Middle 1216 elements of 1728
picture
elements
35 Recording width capability 864 picture
elements along scan line length of 107 ±
mm 1%
Middle 864 elements of 1728
picture
elements
36 Recording width capability 1728 picture
elements along scan line length of 151 ±
mm 1%
Invalid
37 Recording width capability 1728 picture
elements along scan line length of 107 ±
mm 1%
Invalid
38 Reserved for future recording width
capability.
39 Reserved for future recording width
capability.
40 Extend field Extend field
41 R8×15.4 lines/mm R8×15.4 lines/mm
42 300×300 pels/25.4 mm 300×300 pels/25.4 mm
43 R16×15.4 lines/mm and/or 400×400 pels/
25.4 mm
R16×15.4 lines/mm and/or 400×
400
25.4 mm
44 Inch based resolution preferred
Resolution type selection
"0" : neuritic based resolution
"1" : inch based resolution
45 Metric based resolution preferred Don’t care
46
Minimum scan line time capability for
higher resolutions
"0" : T
15.4
= T
7.7
"1" : T
15.4
= 1/2T
7.7
Don’t care
47 Selective Polling capability Set to "0".
48 Extend field Extend field
Note 1 - Standard facsimile units conforming to T.2 must have
the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have
the following capability : Index of cooperation (IOC)=264.
Note 3 - Standard facsimile units conforming to T.4 must have
the following capability : Paper length=297 mm.
201