12. REPLACEMENT PARTS LIST
Notes:
1. The marking (RTL) indicates that the Retention Time is limited for
this item.
After the discontinuation of this assembly in production, the item
will continue to be available for a specific period of time. The
retention period of availability is dependent on the type of
assembly, and in accordance with the laws governing parts and
product retention.
After the end of this period, the assembly will no longer be
available.
2. Important safety notice
Components identified by mark have special characteristics
important for safety. When replacing any of these components,
use only manufacture's specified parts.
3. The S mark indicates service standard parts and may differ from
production parts.
4. RESISTORS & CAPACITORS
Unless otherwise specified;
All resistors are in ohms ( ) k=1000 , M=1000k
All capacitors are in MICRO FARADS ( F) P= F
*Type & Wattage of Resistor
12.1. CABINET AND ELECTRICAL PARTS
12.1.1. OPERATION PANEL BLOCK (1)
255
To Next Page
Loading...
