Operating Instructions
130
2.24 Specifying Operation Time
The Operation Time page allows you to limit the operation time. The camera image
turns to a gray screen outside the operation time.
Note
• If you wrongly set the time period, your privacy may be seen. Confirm the
time period after the setup.
• If you access the camera as an administrator, you can view the image
outside the time period.
1. Click [Operation Time] on the Setup page.
2. Click [No.] to set the operation time.
Note
If No. 1—7 are disabled, the camera can always be operated.
3. Check [Enable], set the time, and click [Save]
• Clicking [Cancel] takes you back to the previous page.
To Next Page
Loading...
