Panasonic KX-HCM110A

Operating Instructions
[For assistance, please call: 1-800-272-7033] 63
3. Click [Save] when finished.
• New settings are saved.
• When finished, "Success!" is displayed.
4. Click [Go to UPnP page].
• The UPnP page is displayed.
2.7.1 Connecting the Camera to a Router Supporting
UPnP™ (IPv4 Only)
To allow access from the Internet with a router supporting UPnP
TM
, follow the
procedures shown on the Getting Started.
Note
• In some routers, the UPnP
TM
feature is disabled by default. Enable your
router's UPnP
TM
feature following the router manual before you set up the
camera. See the Panasonic Network Camera support website at http://
panasonic.co.jp/pcc/products/en/netwkcam/ for details.
• If the maximum idle time is set in PPPoE or PPTP connection with your
ISP, disable it on the router. See the router manual for details.