Operating Instructions
44
4. Click [Save] when finished.
• New settings are saved.
• When finished, the following page is displayed.
Note
The current network settings are shown on the Status page in the Maintenance
section (see page
135).
5. Click [Restart].
• The camera restarts, and the Top page is displayed.
• If the camera is restarted, all buffered images on the internal memory are
deleted.
• Checking [Yes] for [Allow Access from the Internet] on [Automatic Setup]
may not display the Top page, because the port number may change. Use
the Setup Program to access the camera.
DHCP Setup Static Setup
• Clicking [Cancel] takes you back to the previous page without
saving changes.
To Next Page
Loading...
