Panasonic KX-MB262CX

KX-MB262CX/KX-MB772CX
2.
2.
D
is
ca
rd
i
ng
of
P
.
C
.
B
oa
rd
When discarding P
. C. Board,
delete all
personal information such as telephone
directory and caller list o
r scrap P
. C. Board.
2.
3.
IN
SU
LA
TI
ON
RE
SI
ST
AN
CE
TE
ST
1.
Unplug the power cord an
d short the two prongs of the plug w
ith a jumper wire.
2.
Tur
n on the power swi
tch.
3.
Measure the resistanc
e value with an ohmmeter between the jumpered AC plug and each exposed met
al cabinet part
(screw heads, control shafts, bottom frame, etc.).
Note: Some exposed parts may be
isolated from the
chassis by design. These will
read infinity.
4.
If the measurement is outside the specified limits
, there is a possibility of a shock hazard.
2
.
4
.
B
A
T
T
E
R
Y
C
A
U
T
I
O
N
CAUTION
Danger of explosion if the battery is replaced incorrectly. Replace only with the same or equivalent type recommended by the
manufacturer
. Discard used batteries according
to following caution:
Disposal of lithium batteries should be
performed by permitted, professional disposal firms knowledgeable in
state government
federal and local
hazardous materials and hazardous waste transportation and
disposal requirements.
A battery continues to have no tr
ansportation limitations
as long as it is separated to prev
ent short circuits
and packed in strong
packaging.
Commercial firms that dispose of any quantity of
lithium cells should have a
mechanism in place to account for their
ultimate dis-
position. This is a good
practice for all types of commercial or industrial waste.
Recommend Type Number:
CR2354 (BAT300) Manufactured by MATSUSHITA
2.5.
LASER BEAM AND FUSER UNIT SECTION
•
The printer of this unit utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
•
The fuser unit is inside of the unit and gets hot. Do not touch it when removing the jammed paper or cleaning the lower glass.