On the process of the transfer, the transferred toner is weakly attached on the paper. Fixing means the process to fix the toner on
the paper permanently. The fixing part melts the toner at the high temperature using the halogen heater. The toner is fixed on the
paper by the heat and pressure through the fixing part with the image. The surface of the heat roller is rosined by Teflon and lubri-
cated to prevent from attaching the toners. The press roller
is made of silicon, and its spring
The fixing part becomes high temperature, so the thermistor and
the two thermostats are provided.
The thermistor touches the heat roller and check the temperature to feed
back to the control circuit. The surface temperature
The thermostat is located near the heat roller, and it turns OFF the power when the temperature around the thermostat
To Next Page
Loading...
