When new calls have been received, the display will show the number of new calls.
The number of new calls will be cleared after viewing all caller information.
Example: 4 new calls have been received.
Note:
- When you receive a call from the same phone number you stored
with a name in the phonebook, the display will show the stored
name.
- If the unit is connected to a PBX system, you may not receive the
caller information.
- When the caller dialled from an area which does not provide Caller
ID service, will be displayed.
- When the caller requested not to send caller information, either no
information or will be displayed.
- The display will not show caller information while using the
handset for an intercom call. However, the caller information will
be stored.
- Certain service providers send caller information between the first
and second rings. If the display does not show caller information
after a few rings, follow these instructions to set DTMF mode.
7.3. Before Requesting Help (Troubleshooting)
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
17
To Next Page
Loading...
