Panasonic KX-TCD430FXB

Items
Adjustment
Point
Procedure*
Check
(G)
*
DTMF Generator
Confirmation
-
1. Connect J1 (Telephone Socket) to DTMF tester.
2. Execute the command "hookoff" and "dtmf_up".
3. Confirm that the high frequency (1477.06Hz) group is -6.5dBm ~ -9.5dBm.
4. Execute the command "dtmf_lo".
5. Confirm that the low frequency (852.05Hz) group is -9dBm ~ -12dBm.
IC2,R32,C22,
C14,C13,Q6,
R19,R20,C12,
C2,R77,D3,
R7,R8,R9,
(H)
*
Transmitted
Power
Confirmation
- Remove the Antenna before starting step from 1 to 4.
1. Configure the DECT tester (CMD60) as follows;
<Setting>
-Test mode: FP
-Traffic Channel: 5
-Traffic Slot: 4
-Mode: Loopback
-PMID: 0000
2. Execute the command "testmode".
3. Initiate connection from DECT tester. (“set up connect”)
4. Confirm that the NTP value at ANT is 20dBm ~ 25dBm.
IC2,IC3,L1,
C75,C69,C48,
C67,C76,C57,
DA1,R66,R67,
R78,R79,C54,
37