Panasonic KX-TCD440E

Helpline Tel. No. :U.K. 08700 100 076 R.O.I. 01289 8333 35
Useful Information
redialled. Redial the number manually.
The handset beeps intermittently and/or
074 flashes.
L Fully charge the batteries (page 7).
I fully charged the batteries, but 074
still flashes.
L Clean the charge contacts and charge
again (page 7).
L It is time to replace the batteries (page 8).
7 disappears and the unit stops
charging when the handset is on the
base unit.
L Nickel cadmium batteries are inserted
when the battery type is set to “NI-MH”.
Change the battery type setting to “NI-
CD” (page 21).
Caller information is not displayed.
L You must subscribe to Caller ID service.
While viewing caller information, the
display returns to standby mode.
L Do not pause for over 60 seconds while
searching.
I cannot register a handset to a base unit.
L The maximum number of base units (4)
are already registered to the handset.
Cancel unused base unit registrations
from the handset (page 31).
L The maximum number of handsets (6) are
already registered to the base unit. Cancel
unused handset registrations from the
base unit (page 31).
L You entered the wrong PIN number. If you
forget your PIN, consult your nearest
Panasonic service centre.
L Locate the handset and the base unit
away from other electrical appliances.
Answering system (KX-TCD445
only)
The answering system is turned on, but
caller messages are not recorded.
L The recording time is set to “GREET
ONLY”. Select “1 MINUTE” or
“UNLIMITED” (page 29).
L Message memory is full. Erase
unnecessary messages (page 26).
I cannot operate the answering system
with the handset.
L Another handset user is using the
answering system or changing base unit
settings. Wait for the other user to finish.
L A caller is leaving a message. Wait for the
caller to finish.
L The handset is too far from the base unit.
Move closer.
I cannot operate the answering system
remotely.
L You are entering the wrong remote
access code. Turn remote operation on
using the handset and select a new code
(page 27).
L You are pressing the dial keys too quickly.
Press each key firmly.
L The answering system is turned off. Turn
it on (page 25, 28).
L You are using a pulse telephone. Try
again using a touch tone phone.
While recording a greeting message or
listening to messages, the unit rings and
recording stops.
L A call is being received. Answer the call
and try again later.
TCD440_445E.book Page 35 Friday, February 27, 2004 4:22 PM