– 5 –
Programming via direct commands
You can program most features using “direct commands”—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
1 Press {MENU}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
4 Press {Save}.
5 Press {OFF} to exit programming mode.
Direct commands chart
Feature Feature code Setting code
Ringer volume {1} {1} {1}: Low {2}: Medium
{3}: High {0}: Off
Ringer tone {1} {2} {1}–{3}: Tone pattern 1–3
{4}–{7}: Melody pattern 1–4
Voice enhancer {5} {1}: On {0}: Off
LCD contrast {0} {1} {1}–{6}: Level 1–6
Auto talk {0} {3} {1}: On {0}: Off
Set dial mode {0} {5} {1} {1}: Pulse {2}: Tone
Change language {0} {8} {1}: English {2}: Spanish
Message alert {0} {#} {1}: On {0}: Off
Important information about subscription services
In order to use Caller ID, Call Waiting, Call Waiting Caller ID (CWID), or Voice Mail,
you must first contact your telephone company and subscribe to the desired
service.
L For more information, contact your telephone company.
If the Call Waiting Caller ID (CWID) feature does not function:
L You may need to contact your telephone company to activate this specific service, even
if you already subscribed to both Caller ID and Call Waiting with Caller ID services
(CWID).
TG5421_5422_5423_QG(e).fm Page 5 Tuesday, November 16, 2004 2:29 PM
To Next Page
Loading...
Need help?
General
