Note:
R I
f the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
c
harge again.
Removing the battery
Registering a handset to a base unit
1 B
ase unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
then repeat this step.
2 Handset:
Place the handset on the charger, then wait until a long beep sounds and
is displayed.
N
ote:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
6
For assistance, visit www.panasonic.ca/english/support
Installation
To Next Page
Loading...
