Note:
R The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold MOFFN for few
seconds to turn the handset on.
1 Handset:
Lift the handset and press MOFFN.
2 Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
then repeat this step.
3 Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows “Please
wait for 1 minute.”.
4 With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
is displayed.
Note:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
4
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Installation
To Next Page
Loading...
