Page 4
3 GETTING CONNECTED
This section details the setting up a new TGP600 Base unit and the included Desk phone.
Step 1: Set up the new KX-TGP600 Base Unit
• Connect the Ethernet cable (included) to your base unit and to the Ethernet port located
on the back of your TIPT switch/PC.
• Connect the AC adapter for the base unit to the base unit and a power socket.
Ensure that you have plugged the adapter in securely.
• The status indicator on the Base Unit will flash as follows.
1) Solid – Red: When the base unit is turned on, the status indicator turns red for ~40
seconds.
2) Slow Flashing – Amber: The base unit is obtaining an IP address / configurations and
registering with your phone system. Please wait.
3) Solid – Green: The base unit is connected to the TIPT network.
Step 2: Set up the included KX-TPA65 Desk Phone
• Attach the AC adapter to the desk phone and a power socket.
• Attach the Corded Handset and headset (if required) to the desk phone.
Step 3: Attach the Stand to the KX-TPA65 Desk Phone
• Insert the stand into the hooks located in the unit.
• Gently rotate the stand in the direction indicated until it is released
Step 4: Adjusting the Stand Position
• Push the PUSH marks in the direction indicated, with both hands, and tilt the stand until it
becomes fixed in the desired position.
• Choose the High Position or Low Position.
To Next Page
Loading...
