To Next PageTo Next Page
How to fix a Panasonic Handsets that doesn't ring?
If your Panasonic handset isn't ringing, the ringer volume might be set to "Off". Adjust the ringer volume level. Also, Silent Mode might be activated. In this case, turn off Silent Mode.
Why is there so much noise on my Panasonic Handsets?
Frequent noise during calls on your Panasonic handsets might be due to interference from nearby electrical appliances or being too far from the base unit. Try placing the handset and base unit away from other electrical appliances and move closer to the base unit.
What to do if Panasonic Handsets stops working during operation?
If your Panasonic handset stops working during operation, an unknown error may have occurred. Try turning the handset off and then back on. Alternatively, re-insert the battery and try again.
Why does my Panasonic Handsets beep after charging?
If your Panasonic handset beeps and indicates it needs to be charged even after charging for 6 hours, the battery charge contacts may be dirty. Clean the battery charge contacts without damaging them and charge once more. It may also be time to replace the batteries with new ones.
What does 'No Service' mean on my Panasonic IP Phone?
If your Panasonic IP Phone displays "No Service" and you hear beep tones, it could mean the handset or desk phone is out of range. Try moving closer to the base unit or try again later.
How to fix a Panasonic IP Phone handset that does not work?
If your Panasonic IP Phone handset isn't working, it might be due to a drained battery. Charge the battery fully. Alternatively, the power might be off. Turn it on, or try re-inserting the battery and setting the handset on the charger.
Why can't I dial on my Panasonic IP Phone?
If you cannot dial on your Panasonic IP Phone, the number you're trying to dial might be restricted by your phone system. Another possibility is that key lock mode is activated. To cancel it, press and hold the key lock button for about 2 seconds. Also, the radio channel may be busy, so try again later.
Why do I hear two short beeps during a conversation on my Panasonic Handsets?
If you hear two short beeps during a conversation on your Panasonic handset, the radio signal is weak. Try moving closer to the base unit.
Why is the charge indicator flashing red on my Panasonic Handsets?
If the charge indicator flashes red rapidly on your Panasonic handset, the charger is not connected properly. Make sure the battery is inserted properly and set the handset in the charger correctly.
Why is it hard to have a conversation on Panasonic Handsets in Hands-free mode?
If it's difficult to have a conversation in Hands-free mode on your Panasonic handset, the microphone might be facing the wrong direction or is obstructed during the conversation. Ensure the front of the handset faces you, and the microphone is not covered.
General| Speakerphone | - |
|---|---|
| Voice codecs | G.711a, G.722, G.722.2, G.729A |
| Handset type | Wireless handset |
| Product type | IP Phone |
| Product color | Black |
| DECT connectable | Yes |
| Number of handles included | 1 pc(s) |
| Number of DECT wireless handsets | 8 |
| Display diagonal | 1.8 \ |
| Frequency band | 1.88 - 1.90 GHz |
| Lines quantity | - lines |
| Phonebook capacity | 500 entries |
| Networking standards | IEEE 802.1Q, IEEE 802.3af |
| Ethernet LAN (RJ-45) ports | 1 |
| Standby time | 200 h |
| Battery type | AAA |
| Battery capacity | 630 mAh |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
| Harmonized System (HS) code | 85171800 |
Weight and Dimensions| Depth | 25.5 mm |
|---|---|
| Width | 47.8 mm |
| Height | 153.2 mm |
| Weight | 117 g |
