Value Range
• 0: SRTP
• 1: RTP/SRTP
• 2: Panasonic Original
• 3: SRTP/RTP
Note
• 0: Use only SRTP for outgoing and incoming calls.
• 1: Use only RTP for outgoing calls, and RTP or SRTP for
incoming calls.
• 2: Use RTP or SRTP for both outgoing and incoming calls. This
value is valid only when the unit is connected to a Panasonic
PBX. "SRTP_MIX_TRANSFER_ENABLE_n" must also be set to
"Y".
• 3: If you are using "RTP/AVP" and append "a=crypto", and the
response message includes "a=crypto", the conversation will
be established with SRTP. If "a=crypto" is not included, the
conversation will be established with RTP.
Default Value 1
Web User Interface Reference SRTP Mode (Page 147)
SRTP_MIX_CONFERENCE_ENABLE_n
Parameter Name Example SRTP_MIX_CONFERENCE_ENABLE_1,
SRTP_MIX_CONFERENCE_ENABLE_2, …,
SRTP_MIX_CONFERENCE_ENABLE_8
Value Format BOOLEAN
Description Specifies whether to allow conferences where each participant can use
either SRTP or RTP.
Value Range
• Y: Enable
• N: Disable
Default Value
N
Web User Interface Reference Enable Mixed SRTP & RTP by Conference (Page 147)
SRTP_MIX_TRANSFER_ENABLE_n
Parameter Name Example SRTP_MIX_TRANSFER_ENABLE_1,
SRTP_MIX_TRANSFER_ENABLE_2, …,
SRTP_MIX_TRANSFER_ENABLE_8
Value Format BOOLEAN
Description Specifies whether to allow call transfers between a user who is using
SRTP and a user who is using RTP.
Value Range
• Y: Enable
• N: Disable
Document Version 2017-07 Administrator Guide 307
5.3.27 SRTP Settings
To Next Page
Loading...
