Configuration File Reference BUSY_TONE_TIMING (Page 330)
4.6.5.3 Ringing Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of ringback tones using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If the value for this setting is "440,480", the unit will use a mixed
signal of a 440 Hz tone and a 480 Hz tone.
Default Value 440,480
Configuration File Reference RINGBACK_TONE_FRQ (Page 331)
Tone Timings
Description Specifies the pattern, in milliseconds, of ringback tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 60,2000,3940
Configuration File Reference RINGBACK_TONE_TIMING (Page 332)
4.6.5.4 Stutter Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of stutter dial tones to
notify that a voice mail is waiting, using 2 whole numbers separated by
a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
Default Value 350,440
Document Version 2017-07 Administrator Guide 165
4.6.5 Tone Settings
To Next Page
Loading...
