Default Value No
Configuration File Reference RTCPXR_ENABLE_n (Page 306)
RTCP&RTCP-XR Interval
Description Specifies the interval, in seconds, between RTCP/RTCP-XR packets.
Value Range 5–65535
Default Value 5
Configuration File Reference RTCP_INTVL_n (Page 305)
SRTP Mode
Description Selects the mode of SRTP feature.
Value Range
• 0: SRTP
• 1: RTP/SRTP
• 2: Panasonic Original
• 3: SRTP/RTP
Note
• 0: SRTP
Use only SRTP for outgoing and incoming calls.
• 1: RTP/SRTP
Use only RTP for outgoing calls, and RTP or SRTP for incoming
calls.
• 2: Panasonic Original
Use RTP or SRTP for both outgoing and incoming calls.
This value is valid only when the unit is connected to a
Panasonic PBX.
"SRTP_MIX_TRANSFER_ENABLE_n" must also be set to "Y".
• 3: SRTP/RTP
If you are using "RTP/AVP" and append "a=crypto", and the
response message includes "a=crypto", the conversation will
be established with SRTP. If "a=crypto" is not included, the
conversation will be established with RTP.
Default Value 1: RTP/SRTP
Configuration File Reference SRTP_CONNECT_MODE_n (Page 306)
Enable Mixed SRTP & RTP by Conference
Description Selects whether to allow conferences where each participant can use
either SRTP or RTP.
Value Range
• Yes
• No
Document Version 2017-07 Administrator Guide 147
4.5.4 VoIP Settings [Line 1]–[Line 8]
To Next Page
Loading...
