Note
• Changes to the settings on this screen are applied when the message "Complete" appears after clicking
[Save]. Because the IP address of the unit will probably be changed if you change these settings, you
will not be able to continue using the Web user interface. To continue configuring the unit from the Web
user interface, log in to the Web user interface again after confirming the newly assigned IP address
of the unit using the phone user interface. In addition, if the IP address of the PC from which you try to
access the Web user interface has been changed, close the Web port once by selecting "Off" for
"Embedded Web" on the unit (® see Opening/Closing the Web Port in 1.1.6.3 Before Accessing
the Web User Interface).
4.3.1.1 IP Addressing Mode
IP Addressing Mode
Description Selects the IP addressing mode.
Value Range
• IPv4
• IPv6
• IPv4&IPv6
Default Value IPv4
Configuration File Reference IP_ADDR_MODE (Page 212)
84 Administrator Guide Document Version 2017-07
4.3.1 Basic Network Settings
To Next Page
Loading...
